No console display

Article author
Horizon Fitness
  • Updated

Resolution: Power source

  1. Verify that the power cord is securely plugged into the wall outlet.
  2. Verify that the treadmill switch is turned on.

Resolution: Crimped power cable

  1. Unplug treadmill from wall outlet. Wait 60 seconds, allowing lower board to discharge built up energy.
  2. Check power cord for pinches or crimps.
  3. Verify that the treadmill is on a dedicated 15-amp circuit. CONTACT AN ELECTRICIAN TO VERIFY IF NECESSARY.

Resolution: Tripped circuit breaker

  1. Find the power control box for outlet and verify that specified circuit has not been tripped. CORRECTIVE ACTION: Reset breaker and try machine again.

Resolution: Cable connections

  1. Turn the power off, unplug the power cable and wait 60 seconds. Remove the motor cover. Wait until all red LED lights have gone off on the motor control board before proceeding.
  2. Next, verify that none of the wires connected to the lower board are loose or disconnected
  3. Turn the power off, unplug the power cable and wait 60 seconds. Remove the motor cover. Wait until all red LED lights have gone off on the motor control board before proceeding. Next, verify that none of the wires connected to the lower board are loose or disconnected.

Was this article helpful?

0 out of 1 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.